杭州叉车1.5吨用什么型号叉车电瓶？推荐使用贝朗斯品牌24-6DB420，48V420Ah，标准配套容量，价格实惠，服务到位，全国联保，免费提供安装服务。杭州叉车蓄电池具备动力5年的设计寿命，在后续使用过程中， 叉车蓄电池短路使电池的正负极发生了接触造成，其原因比较复杂。一方面是制造过程原因，电极的表面有毛刺，刺破了隔膜引起正负极短路，或者是制造的时候工艺不当造成；另一方面是使用过程造成，电池过热，隔膜融化造成的短路。www.ccsobattery.com叉车蓄电池厂家 杭州叉车1.5吨叉车蓄电池多少钱呢？我们建议销售价格约1.7万左右， 在安装叉车电池时，应使用的工具应采取绝缘措施，连线时应先将电池以外的电器连好，经检查无短路，*后连上蓄电池，布线规范应良好绝缘，防止重叠受压产生破裂。通过这些细致的工作，才能更好的预防叉车电池短路，使叉车电池更安全的使用，寿命也更长。 杭州叉车蓄电池使用维护方法：
杭叉电池箱体上如有箱盖或其他遮盖物,充电前必须移开或打开,确保充电时产生的可燃气体充分散发,在充电完成后30分钟后可合上遮盖物.充电房内应该通风良好,室内充电房要安装排风扇.

1. 拨开蓄电池电缆和电瓶车电缆的接插头连接.
2. 打开蓄电池上的盖板，测量电解液的密度，如果电解液的密度小于公斤/升,说明蓄电池已过度放电(放电深度超过了80%),应提醒使用者注意,避免多次发生而缩短电池的寿命.
3. 测量电解液的温度，如果大于45℃，则应等蓄电池冷却后再继续如下步骤。
4. 接上蓄电池与充电机电缆之间的插头。如配备Trak®air（空气扰动系统）请确认空气管路已接上。如配备自动加水系统，接上水管。
5. 打开充电机的充电开关，开始充电。
6. 充电结束后，先关充电机电源，然后拔开蓄电池和充电机的电缆插头连接。
7. 如蓄电池配备半自动水液补充系统，接上水管插头，结束后拔离插头。
8. 如没有蓄电池自动或半自动水液补充系统，则要检查电解液的充电后的液面高度,如液位低于容许高度(低于加水塞)，则应补充符合标准的蒸馏水或去离子水(加水塞*低处向上1-2厘米)，但不可加入任何酸液。
9. 加水必须在充电后进行.充电前加水,可能导致充电时酸液溢出.
10. *后,接上蓄电池和电瓶车的电缆插头,电动车可投入使用.
11. 
12. What kind of forklift battery is used in Hangzhou forklift 1.5 tons? Recommend the use of shell lens brand 24-6DB420, 48V420Ah standard, supporting capacity, price, service in place, Quanguolianbao, provide free installation services. Hangzhou forklift battery has 5 years of power design life, in the subsequent use process, the forklift battery short circuit makes the battery positive and negative contact, the reason is more complex. On the one hand is the manufacturing process, the electrode surface has a burr, punctured diaphragm caused by negative short circuit, or the time of manufacturing process caused by improper use; on the other hand is the process caused by overheating of the battery short circuit caused by melting the diaphragm.
    How much is the 1.5 ton forklift battery in Hangzhou forklift truck? We suggest that the sales price of about 17 thousand or so, in the installation of forklift battery, should use the tools insulation measures should be taken, the connection should be other than the first electrical battery connected, and after inspection without short-circuit, and finally connected to the battery, the standard wiring should be well insulated to prevent overlap by pressure generating rupture. Through these meticulous work, can better prevent forklift battery short circuit, make forklift battery more safe use, longer life.
    Usage and maintenance method of Hangzhou forklift battery:
    Hangcha battery box for box cover or other covering, before charging must be removed or opened, the combustible gas generated during charging to ensure sufficient emissions in after charging for 30 minutes on the cover. The charging room should be well ventilated, indoor charging room to install the fan.
    Push the plug connection between the battery cable and the cable of the battery truck
    Open the cover on the battery, measuring the density of electrolyte, if the electrolyte density less than kg / L, indicates that the battery has excessive discharge (discharge depth of more than 80%), should remind users to pay attention to, avoid repeated and shorten the battery life.
    Measure the temperature of the electrolyte. If it is greater than 45 degrees, wait for the battery to cool down and proceed with the following steps.
    Connect the plug between the battery and the charger cable. If equipped with Trak air (air disturbance system), make sure the air line is connected. If equipped with automatic water system, connect to the water pipe.
    Turn on the charging switch of the charger and start charging.
    After charging, first turn off the charger power, then unplug the battery and the charger cable plug connection.
    If the battery is equipped with a semi-automatic water supply system, connect the water pipe plug and pull the plug out at the end.
    If there is no battery automatic or semi automatic water supplement system, to check the liquid level of electrolyte after charging, if the level is below the allowable height (below the water plug), should be added in accordance with the standards of the distilled water or deionized water (water plug to the lowest 1-2 cm), but can not add any acid.
    Adding water must be done after charging. Adding water before charging may cause acid overflow when charging
    Finally, connect the battery and the cable plug of the battery car, the electric car can be put into use